QuadCopter with CC3D and LibrePilot


A few months ago I received a drone with a defect.

Learning online I found info on power distribution and power regulators needed.


After finishing the power distribution connections I found the CC3D had blown up diodes.
Installing the new controller received with the drone was no problem.


Now everything was in place I could configure the CC3D with LibrePilot and give it a test run while locked to my workmate.

The EWRF TS5823 FPV transmitter and COMS 1000TVL camera, received from BangGood are installed on the drone.
The FPV receiver / display is mountable to my controler / transmitter.

A preview/howto can be found on my YouTube channel.

More info will be available in the near future. And, check my YouTube channel !